Back to Blog
Tips & Care 2026-11-05 Ron’s Cigar Store 0 views

How to Season a Wenge or Walnut Wood Humidor

How to Season a Wenge or Walnut Wood Humidor

Seasoning a new Spanish cedar–lined humidor takes about a week. Follow this step-by-step process for wenge and walnut humidors, with humidity targets and common mistakes to avoid.

Quick answer

Season a new wenge or walnut humidor by lightly wiping the Spanish cedar interior with distilled water, charging the humidifier, and closing the lid for about a week. Aim for a stable 68–72% relative humidity before you add cigars.

Why Spanish cedar needs a slow start

Both the Wenge Humidor and the Walnut Humidor are lined with Spanish cedar, a wood that absorbs and releases moisture slowly. If you rush the process, the cedar can warp or the seal can loosen before the wood has adjusted.

Seasoning gives the cedar time to reach equilibrium with the humidifier, so the first cigars you store don’t dry out or absorb excess moisture from fresh wood.

What to skip during seasoning

Don’t soak the interior or leave standing water in the bottom—Spanish cedar can stain or swell. Propylene glycol solutions are for charging the humidifier, not for wiping the wood.

If your home is very dry in winter, expect seasoning to take a few days longer. Check the hygrometer daily rather than opening the lid repeatedly.

Seasoning steps for a new wood humidor

  1. Wipe the cedar lightly: Dampen a clean, lint-free cloth with distilled water and wipe the Spanish cedar interior once, using light pressure. Common mistake: soaking the wood until water pools—stop before the surface looks wet. Use distilled water only; tap water leaves mineral deposits in the cedar.
  2. Charge the humidifier: Fill the humidifier with distilled water or the manufacturer’s solution according to its instructions, then blot any excess so it doesn’t drip. Common mistake: overfilling, which can leak onto the cedar. If your humidifier uses propylene glycol, follow its ratio rather than filling with water alone.
  3. Close the lid and wait: Place a calibrated hygrometer inside, close the lid, and leave the humidor closed for 24 hours. Common mistake: opening the lid every few hours to check, which releases the moisture you’re trying to build. Resist the urge to peek; one daily check is enough.
  4. Recharge and repeat: After 24 hours, check the hygrometer reading. If it’s below 65%, recharge the humidifier and close the lid for another 24 hours. Repeat until the reading holds steady at 68–72% for two consecutive days. A reading that keeps dropping means the cedar is still absorbing moisture—keep going.
  5. Verify stability before adding cigars: Once humidity holds at 68–72% for two days, add your cigars and check again after 24 hours. Common mistake: filling the humidor the moment it hits target, before the reading has stabilized. If humidity drops sharply after loading, remove the cigars and season for another day or two.

Humidors in this guide

  • Wenge Humidor: Spanish cedar lining with a 13 7/16” x 10 5/8” x 4” body that holds about 100 cigars. The cedar lining is what you season, and the 100-cigar capacity means one humidifier can serve the whole box once humidity is stable.
    Wenge Humidor
    Wenge Humidor
  • Walnut Humidor: Spanish cedar lining and a locking lid on a 13 7/16” x 10 5/8” x 4” body that holds about 100 cigars. The lock helps keep the lid closed during the seasoning week, which is when a tight seal matters most.
    Walnut Humidor
    Walnut Humidor

Related Articles

Customer Service
Home
Products
Cart
Profile