S.T. Dupont Stand Padron Cutter: Safe Use Guide

By Ron’s Cigar Store | Published: 2026-11-01

Category: How-to Guides

Learn how to use the S.T. Dupont Stand Padron cutter safely with a step-by-step technique, common mistakes to avoid, and practical cigar cutter safety tips.

Quick answer

Use the S.T. Dupont Stand Padron cutter by placing the cigar flat on a stable surface, inserting only the cap into the opening, and closing the blade in one smooth motion. Keep your fingers clear of the blade path and never force a cut.

Why the Stand Padron needs a deliberate cutting motion

The Stand Padron is a limited collaboration piece finished in yellow gold and brown lacquer, so it deserves the same care you give a good cigar. A deliberate, single cut protects both the cap and the cutter's finish.

A dull or rushed cut can tear the wrapper and leave loose tobacco in your mouth. Taking an extra second to position the cigar correctly prevents most problems.

When to skip the cutter entirely

If the cigar already has a clean, open draw, you may not need to cut it at all. A pigtail cap or a pre-punched cigar often only needs a small snip or no cut.

For figurados with a tapered head, start with a shallow cut and test the draw before going deeper. Removing too much cap is harder to fix than removing too little.

Step-by-step: safe cutting with the Stand Padron

Set up a stable cutting surface: Place the cutter flat on a table or hold it firmly in your non-dominant hand. Make sure the opening faces you and the blade moves freely. Never cut while holding the cutter in the air with only your fingers; a slip can send the blade toward your hand.
Identify the cap line: Find the rounded cap at the head of the cigar. You want to remove only the very tip, about 2–3 mm, leaving the shoulder intact. Cutting below the shoulder can cause the wrapper to unravel; when in doubt, cut less.
Insert the cigar and check the angle: Slide the cigar into the opening until the cap touches the back of the cut. Keep the cigar perpendicular to the blade, not tilted. An angled cut produces an uneven draw and wastes wrapper leaf.
Close the blade in one smooth motion: Squeeze or press the cutter closed with steady pressure. Do not saw back and forth; one clean motion gives the cleanest edge. If you feel resistance, stop and check for a tobacco stem or a misaligned cigar rather than forcing it.
Inspect the cut and test the draw: Open the cutter, remove the cigar, and look at the cap. The cut should be flat and even. Take a cold draw to check airflow. If the draw is tight, make a second very shallow cut rather than cutting deeply the first time.
Clean and store the cutter: Wipe the blade with a soft cloth after use to remove tobacco residue. Store the cutter closed in a dry place, away from moisture and hard objects. Never rinse the cutter under water; moisture can damage the finish and the mechanism.

Product facts

S.T. Dupont Stand Padron: S.T. Dupont x Padrón collaboration with yellow gold finishes that echo the Padrón cigar band and brown lacquer detailing. The decorative finish means you should avoid dropping or twisting the cutter, and keep it away from keys or loose change in a pocket.
S.T. Dupont Stand Padron